- IMO
- 9515101
- MMSI
- 538004642
- Call Sign
- V7YE6
Technical Specifications
Key Figures
Live Tracking
Current Position
Where it waited most
Most time stopped at Port of Algiers — 3 h across 2 stays.
- 1Port of Algiers3 h · 2×
Derived from the AIS track — runs of near-zero speed (anchored, moored or drifting) snapped to the nearest port. Builds up as we observe the vessel.
Resolved from the live AIS destination. Distance is the real sea route (around land and through canals); the computed ETA is at the vessel’s passage speed. A destination is the crew’s stated intent, not a confirmed fixture.
Intelligence
Risk & Sustainability
An independent cross-check of the estimate above for Bulker (segment · size · age · market).
Estimate from $/dwt of similar-size, similar-age ships sold in the last 24 months. Indicative, not a certified valuation.
- AER (CO₂/capacity·nm)
- 5.4
- Fuel burned
- 2,029 t
- Technical
- EEXI (5.17 gCO₂/t·nm)
Verified reported figure. Band is peer-relative, not official IMO CII.
- Port of Algiers0.2 dJun 26, 2026
- Port of Algiers0.3 dJun 25, 2026
- Port of Algiers0.3 dJun 25, 2026
- Port of Algiers0.3 dJun 24, 2026
- Port of Algiers0.6 dJun 18, 2026
AIS-derived from our live feed.
Compliance
Safety Record
- COLLISION - With another vessel or other floating objectSeriousFeb 11, 2026Bécancour, QUEBEC (QC)
On 11 February 2026, the bulk carrier "FEDERAL SATSUKI", while under the conduct of a pilot and assisted by tugs for berthing, reported a collision with the "OCEAN CHARLIE" in Bécancour, QC. The bulk carrier was secured and minor damage to the bow was reported.
- TOTAL FAILURE OF ANY MACHINERY OR TECHNICAL SYSTEMMinorDec 16, 2019Port-Saint-François, QC, QUEBEC (QC)
On 16 December 2019, the bulk carrier "FEDERAL SATSUKI" experienced a problem with its boiler off Port-Saint-François, QC. The vessel proceeded to the nearest anchorage to carry out repairs.
- BOTTOM CONTACTMinorApr 13, 2014St. Lambert, QC, QUEBEC (QC)
On 13 April 2014, the M/V "FEDERAL SATSUKI" made contact with the bottom after experiencing a loss of main propulsion while transiting the South Shore Canal near St. Lambert, QC. No pollution reported.
Recorded marine occurrences naming this vessel.
Operational Status
Activity
Making way at sea speed on its latest broadcast.
Read from the single most-recent AIS broadcast we hold for this hull — we keep no position history, so this is a point-in-time posture, not a dwell inference. Derived in-house from our own AIS feed; weight it by the broadcast age above.
Port calls
1 recent · AIS-detectedArrivals, time in port and the load/discharge inferred from the draught change — detected from AIS track history. An open call means the vessel is still in port (no departure observed yet).
- op. unknown→ · 24 h in port
Method: each call is a run of fixes inside a port’s geofence confirmed by a stop (or an AIS gap); load/discharge is the sign of the draught delta over the call. Indicative — arrivals before our AIS history began read from the first observation.
Where it waits
1 port · 24 h totalTime-in-port summed by port from the AIS-detected port-call history — the ports this vessel has spent the most time at, longest first.
- Port of Algiers· Algeria24 h1 call · 24 h avg
Based on 1 completed call observed since — open calls (no departure yet) are excluded. The distribution sharpens as AIS history accrues.
Composite Risk
Risk Score
Multiple adverse factors, or a hard ship-specific signal, lift this hull above the fleet norm.
A coverage-weighted blend of the 2 components we could read for this hull — the weights renormalise over only the components present, so a thin read is never inflated and a hull is never credited a “safe 0” for a signal it has no row for. This headline is flagged low-confidence (a thin or structural-only read) and should not be treated as a verdict. Higher means riskier. Derived in-house from government-open port-State-control, flag, sanctions and our own vessel data; weight it by the coverage above.
Estimated
Capacity & Classification
Bulker · summer draught 9.4 m · 43.2 t per cm immersion
Estimate only — modelled from deadweight (deadweight regression) using a first-principles hydrostatic model, not measured hydrostatic tables. The design draught it is anchored to is unreliable across the fleet.
density DWT/GT=1.75 is consistent with declared bulker
Declared type is consistent with the class implied by the vessel’s size signals. Inferred via our shared size-based classifier.
Commercial
Voyage Estimate
Fleet Management
Ownership & Management
Visual Archive
Gallery
Explore More
Similar Vessels
Community
Vessel Comments